1. Crayon Rock Cycle - Lesson Plan
- Pass around samples of sedimentary rock. Ask students to observe the rocks and describe some of the similarities between them. As students offer their ideas, write them on the board in one column. You should end up with a list like: First rock type: can see grains, grains can be of different sizes, has layers or streaks, grains come off if you rub it.
- Collect the sedimentary rocks then pass around samples of metamorphic rocks. Ask students to observe the rocks and describe how these rocks are different from the sedimentary rocks. Again, write their ideas in a column on the board. You should end up with a list like: Second rock type: no grains, has crystals, many colors, very hard, swirly patterns.
- Collect the metamorphic rocks then pass around samples of igneous rocks. Ask students to observe the rocks and describe how these rocks are different than the other two types of rocks. Again, write their ideas in a column on the board. You should end up with a list like: Third rock type: no grains, some have crystals, some have lots of holes, uniform texture and pattern throughout the rock, no layers or swirls.
- Tell the students that they have been observing and categorizing the 3 major types of rocks: sedimentary, metamorphic, and igneous rocks. Explain that today, they will be using crayons to model the processes that create each of these 3 types of rock.
- Pass out the handout, crayons, foil, and knife.
- Tell students that they have been given a sample of a crayon rock. Looking at the 3 descriptions on the board, which one is this sample most similar to. It doesn’t have grains, layers or streaks. Thus it is an igneous crayon rock! On their handout, in the box at the top of the circle, have students write “igneous rock”.
- The first step is to create sediment. Have students unwrap their crayons then create a pile of crayon shavings on their piece of aluminum foil by scraping it with the knife. They may trade crayons among themselves to acquire a mixture of colors. Give them around 5 minutes to build up a decent sized pile.
- On the diagram, the arrow from “igneous rock” can be labeled “erosion”. The next box can be labeled “sediment”.
- Now fold over the foil to wrap up the sediment pile. Press down on the pile as hard as you can. Gently unwrap it. The sedimentary crayon rock will be fragile but should hold together in a packed layer.
- Discuss the similarities between the sedimentary crayon rock and the real sedimentary rocks the students observed earlier.
- On the diagram, the arrow from “sediment” can be labeled “lithifaction – compacting and cementing sediments together”. The next box can be labeled “sedimentary rock”. Discuss this process as it occurs in the real world with layers being squeezed under other layers.
- Now get a helper to pass out the cups and go around yourself to fill each cup with hot water. Have another helper place containers for cooled water near each table or cluster of desks.
- Each student should create a little boat for their sedimentary crayon rock and float his or her boat on the hot water. Watch as the heat from the water melts the crayon. Remove the foil when the wax is soft to the touch and the colors have swirled together but not so much that the colors are indistinguishable. Let the metamorphic crayon rock cool.
- Discuss the similarities between the metamorphic crayon rock and the real metamorphic rocks the students observed earlier.
- On the diagram, the arrow from “sedimentary rock” can be labeled “metamorphism – heat and pressure transforms the rock”. The next box can be labeled “metamorphic rock”. Discuss this process as it occurs in the real world with rocks being subjected to intense heat and pressure beneath the surface of the Earth.
- At this point, the temperature of the water the cups may have cooled. Ask students to dump their water into the containers. Go around and refill each cup with hot water.
- Each student should put their metamorphic crayon rock back in the foil boat and float it on the hot water. This time, allow the wax to melt until a smooth pool of liquid wax forms and the colors blend together uniformly. Carefully remove the foil and let the igneous crayon rock cool.
- Discuss the similarities between the igneous crayon rock and the real igneous rocks the students observed earlier.
- On the diagram, the final arrow from “metamorphic rock” can be labeled “melting into magma then cooling”. Discuss this process as it occurs in the real world with rocks being melted deep within the Earth then extruded again as volcanoes or bubbles of magma that do not reach the surface.
- Ask the students if they think this igneous rock could be turned into sedimentary rock? How? Could it be turned directly into metamorphic rock? How? Could a metamorphic rock be turned directly into sedimentary rock? How?
- Add additional arrows across the middle of the rock cycle to illustrate that any type of rock can turn into any other type of rock.
- If there is time, students can experiment with turning their igneous crayon rock into a new sedimentary, metamorphic, or igneous crayon rock.
- Clean up! Students can keep their crayon rocks.
Submitted by irene on Sat, 2006-02-18 10:45